How to connect xenon ?

How to connect xenon ?

Watch the video

How to connect xenon?

Today xenon headlights are the most effective option for lighting.Of course, on this occasion there are disputes, but it is a fact.Right now, a lot of motorists switches to this type of lighting.

It should be noted that earlier installation of such lights mainly carried out on expensive cars and extremely professional.Now it is available to any motorist.

Xenon is by its very nature - is a gas that has one very remarkable feature - when passed through by an electric current, it emits a powerful light.These lights illuminate the road very well, which is why they prefer cars and drivers.

What is needed for proper installation of headlights Xenon

First of all, we must understand that even though this procedure is simple, it is quite laborious and time consuming.After all, the quality of the installation of xenon lamps will depend on the duration of their service and the quality of the lighting.

also need to use some knowledge when calibrating light.As the light of the xenon headlights as close to daylight, at night, he has a greater brightness, which is not very pleasant for drivers traveling in the opposite lane.It is therefore necessary to adjust the headlamp in such a way that the light beam was directed at the road, and not higher.

Also, there are some recommendations that you should consider when installing lights:

  • is not necessary to install to use the heat-resistant adhesive;
  • if you want to install the xenon headlights in the fog, it is preferable to use the ignition blocks 5th generation;
  • firing units must be installed far enough away from the engine and a radiator, to prevent heating;
  • compartment headlights must be protected from moisture.

How to connect xenon own

to install headlights must be thoroughly acquainted with the instructions for installing them.We proceed to the installation itself.The scheme for the majority of standard xenon headlights.

  1. Make sure that your new kit xenon headlights does not have any damage.If they occur, contact your retailer or professional advice, how marriage will affect the performance of the system and what can be done in this situation.
  2. sure to disconnect the terminal from the "+" sign on the battery, such as lights when connected produce very high voltage of 23,000 volts.
  3. Next, perform the dismantling of the old headlights:
    • remove the protective cover from the headlamp;
    • will need to drill a hole in the rear wall lights for the wires from the xenon headlights;
    • in the drilled hole and then insert the rubber ring for best fixing and isolation of the internal space of the car against moisture and dust.At this stage, we prepare it, you do not forget.
  4. Install the xenon headlights in place of the old.Remember that you need to fix the lights securely as possible, because if they are installed incorrectly, it can cause a fire.
  5. xenon Pull the wire through the drilled hole, do not forget the rubber cap, which we prepared earlier.
  6. Set the ignition box in the engine compartment under the hood.For convenience, better to remove the battery, as it will block the access to the compartment lights.Select a location for the unit.At the same time, remember that the cables should not be tensioned.
  7. connected wire xenon headlight units to the ignition, and the other wire coming from the unit, - the wiring to the machine.

your xenon lights are ready for use.Well, for more information on the selection and installation can be obtained from the articles:

  • Select xenon.What better
  • How to install xenon